cecotec Conga 5490 - Before Use; Installation; Robot and Charging Base Installation

30 | CONGA 5490
ENGELSK
3. Before use
Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If
any sign of visible damage is observed, contact immediately with the ocial
Technical Support Service of Cecotec.
4. Installation
Robot and charging base installation
Fig.8.
Connect the charging base to a power supply and store the remaining cable.
It is important to store the remaining cable at the bottom of the charging
base to avoid it from being dragged and disconnected.
Place the charging base against the wall, leaving the safety distance indi-
cated in the below picture.
Note: Ensure a space of at least 1 m on both the left and right side of the
charging base, and a space of at least 2 m in front of it.
Fig.9.
Warning: Do not expose the charging base to direct sun light.
Long press the power button for 3 seconds; when the light indicator turns
on, place the robot on the charging base.
Fig.10.
Steady blue light: ON/operating
Oscillating orange light: Charging
Red light blinks: Error
Note:
Take the robot to the charging base if the battery is low. The robot might not
turn on if the battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned o during charging.
Wet & dry and dust tank installation
Note: It is not suggested to use the scrubbing function for the rst-time use.
Open the tank’s blue silicone lid, ll the tank with water carefully so water
does not come out and close it again. Make sure the silicone clip is properly
closed to avoid water from pilling.