CONGA 5490 | 41
ENGLESK
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from
the product and store it in a dry and safe place. It is suggested to charge the
battery every month in order to avoid damage to the battery.
Do not dispose of waste batteries at will. It is suggested to hand them over
to professional organizations for correct treatment.
9. Troubleshooting
Problem
1. The robot does not start up or does not clean.
2. The robot cannot charge or return to the charging base.
3. The robot does not work properly.
4. The robot emits a strange noise during cleaning.
5. The robot does not clean eciently or dust leaks from the robot.
6. The robot could not connect to Wi-Fi.
7. The robot did not carry out the scheduled cleaning task.
8. The robot does not return to the charging base after spot cleaning or af-
ter changing starting position.
9. The robot does not resume cleaning.
10. The robot is always oine.
11. Connection between the mobile phone and the robot failed.
Solution
1.1. The robot cannot operate with low battery. Allow it to charge before op-
erating it.
1.2. The room temperature is below 0 ºC or above 50 ºC. Operate the robot
in a room where the temperature is between the stated temperature range.
2.1. There are too many obstacles near the charging base, relocate the
charging base to an area free of obstacles.
2.2. Clean the charging terminals.
2.3. Make sure the power switch is turned on.
2.4. The robot is too far away from the charging base, place it closer and try
again.
2.5. There is very little free space around the charging base. Make sure the
charging terminals are clean.
3.1. Turn the robot o, switch it o and turn it on again.
3.2. Once the robot is turned on and has left the charging base, hold down
the Back home button on the robot until it beeps. Immediately after, let go
To Next Page
Loading...
