cecotec Conga 5490 - Cleaning and Maintenance; Main Brush and Silicone Brush Care; Jalisco Brush and Dust Tank Maintenance

CONGA 5490 | 39
ENGLESK
It can be combined with Edge, Spiral, Spot or Smart Area modes. The ro-
bot will carry out 2 full cleaning cycles and then will return directly to the
charging base.
7. Cleaning and maintenance
Main brush
Turn the robot around and press the main brush’s release button to take the
cover out.
Take the main brush out and clean the compartment.
Clean the main brush with the provided tools and use water and soap if
necessary.
Place the main brush in its position and fasten the cover’s clip.
Recommendation: Replace the main brush every 6-12 months to ensure ef-
cient operating (depending on the frequency and type of use).
Fig.25.
Main brush cover
Tab
Main brush
Compartment
Silicone brush
Fig.26.
To clean the silicone brush, follow the instructions on the previous section
to remove it from the robot and wash it with water and soap. Dry it thor-
oughly before assembling it back in order to ensure ecient operation.
Jalisco brush
Fig.27.
To clean the Jalisco brush, follow the previous section’s steps to take it out
and clean it with water. Dry it thoroughly before assembling it back in order
to ensure ecient operation.
Dust tank
Fig.28.
Take the dust tank out.
Open the dust tank cover and empty it.
Use the cleaning brush to clean the inside of the dust tank.
Install the dust tank back in the robot.