cecotec Conga CarpetClean 10000 EasyHome - Troubleshooting

CONGA CARPETCLEAN 10000 EASYHOME
40
ENGLISH
6. TROUBLESHOOTING
If you observe any problem, carefully read this manual and try any possible solutions before
contacting the ocial Cecotec Technical Support Service.
Problem Possible causes Possible solutions
The power button has
been pressed, but the
appliance does not work
The plug is not connected
correctly or is loose, so it
does not make contact.
Turn o the appliance and
connect it again to the mains.
The internal line or power
cord are broken.
Contact the ocial Cecotec
Technical Support Service.
The appliance overheats
and it activates the
protective device.
Read the instructions on the
protective device.
When you press the spray
button, little or no water
comes out
The nozzle is clogged. Remove the suction nozzle
and clean it with water.
The bracket or pump are
damaged.
Contact the ocial Cecotec
Technical Support Service.
It does not vacuum, or it is
too weak
You did not press the power
button.
Press the power button.
The waste-water tank is
full, which activates the
oat valve.
Empty the waste-water tank
and use it again.
The hose does not work
properly.
Check the hose is not cracked,
broken, or clogged.
The waste-water tank is not
correctly installed.
Install the waste-water tank
correctly.
The air inlet sponge is
blocked.
Clean or replace the sponge.