47
ENGLISH
Battery charge and replacement
- To lengthen the battery shelf life, keep the robot charging on the charging base when not
in use.
- Remove the battery and store it in a safe, dry place if the device will not be used for a long
period of time.
To replace the battery, follow the instructions below:
1. Unscrew the 2 screws on the battery slot, remove the battery cover and the battery. Fig. 28
2. Insert the new battery with the battery label facing up. Fig. 29
3. Place the battery and the battery cover in its place and x properly the screws back again.
6. TROUBLESHOOTING
Robot vacuum cleaner
warning
Cause Solution
Steady
red light
1 beep Omnidirectional
wheel error.
Clean the omnidirectional wheel and press
the Start/Pause button to restart the robot
vacuum cleaner.
2 beeps Side brushes
error
Clean the side brushes and press the Start/
Pause button to restart the robot vacuum
cleaner.
3 beeps Suction motor
error
Remove the tank and empty it.
Remove the robot lter and shake o the
dirt.
4 beeps Main brush
error
Remote and clean the main brush and press
the Start/Pause button to restart the robot
vacuum cleaner.
05784_Conga Connected_IM_YV_01220502.indd 4705784_Conga Connected_IM_YV_01220502.indd 47 3/5/22 15:223/5/22 15:22
To Next Page
Loading...
Need help?
General
