45
ENGLISH
cleaning hours.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall o. The high-eciency lter cannot be washed.
Mesh primary lter and sponge lter
The ltering system is featured with a primary mesh lter and a sponge lter, located next to
the high-eciency lter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall o. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot motor and damage it.
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe o any dust from the free-fall sensor located on the
robot lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the Jalisco brush
The Jalisco brush is designed for hard oors. Its micro-bre technology captures dust, sand,
mites and lint eciently in a single pass. This brush is in contact with the oor, and therefore
with dirt, so it can be worn out over time, aecting negatively to the cleaning eciency. For this
reason, it is suggested to replace the Jalisco brush after a maximum of 320 hours.
1. Slightly press the Jalisco brush frame tabs in order to open the slot and remove it. Fig. 31
2. Remove any hair, lint or other dirt trapped in the brush and around the shafts.
3. Clear and clean the robot suction channel. Fig. 32
4. Reinstall the Jalisco brush and its frame.
Recommendation
It is recommended to clean the Jalisco brush once a week with the help of the autoclean brush.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to thoroughly clean edges and corners. These brushes can wear out over time,
05792_Conga Quick&Clean Titanium_IM_YV_01220901.indd 4505792_Conga Quick&Clean Titanium_IM_YV_01220901.indd 45 1/8/22 15:041/8/22 15:04
To Next Page
Loading...
Need help?
General
