cecotec Cumbia CREMMAET COMPACT - Preparing Hot Water; Cleaning and Rinsing Cycle; SETTINGS AND CONFIGURATION; Espresso and Americano Settings

CREMMAET COMPACT
41
ENGLISH
3. Select the desired amount of coee.
4. During grinding (the control panel display shows “g”), press the “ ” or “ ” buttons to
adjust the amount of coee powder. During coee preparation (“ml” is displayed on the
right-hand side of the control panel display), press “ ” or ” to adjust the amount of
liquid coee.
5. Press the “ ” button to prepare two cups of coee.
6. Press “ ” to stop coee preparation.
Preparing hot water
1. Adjust the height of the coee spout and place a cup underneath. Fig. 7
2. Press the hot water button “ ” to dispense hot water.
3. Once the desired amount of hot water is obtained, press the “ ” button on the panel
to stop dispensing water.
Cleaning/Rinsing
1. Adjust the height of the coee spout and place a container underneath. Fig. 7
2. Press and hold down the button “ ” for 3 seconds to start cleaning/ushing of the
coee machine. This function uses 60 ml of water and is automatically deactivated.
Settings and conguration
In standby mode, press and hold the settings button “ ” for 3 seconds to access the
conguration interface.
1. Settings for Espresso and Americano coee. Fig. 8
a. Once inside the setting interface, the Espresso and Americano buttons will ash.
b. Press the Espresso button “ ” or the American button “ “ depending on the type of
coee you want to change.
c. Once you have pressed the desired button, you have accessed the interface for setting
the amount of coee powder. Press “ ” or ‘” ” to increase or decrease the amount of
coee powder.
d. Then, press the Settings/Exit button “ ” to enter the coee ow setting interface:
press “ ” or “ ” to increase or decrease the Espresso ow rate.
e. When the conguration is nished, press the “Settings/Exit “ ” button to advance to
the next step, and press the button 7 times to return to the standby interface.
2. Temperature settings.Fig. 9
After conguring the quantity and ow rate settings, press the Settings/Exit button “
” to enter the temperature settings interface. Press the button “ ” or “ ” to adjust the
temperature.