CED CED7000PRO - Firmware Updates and WinMSS Integration

Updating the Firmware
1. Download the latest rmware le from www.ced
7000pro.com and save it on your PC
2. Turn the timer On and connect to the PC via the mini
USB cable
3. Ensure Status shows Ready
4. Click Update Firmware
5. Locate the previously saved rmware le
6. Click Open
7. Once the Status changes to Finished, click the large
button “Click here to nish and safely un-plug your
timer”.
8. The timer will reset and update to the new rmware.
9. Go to settings->rmware and ensure you are run
ning the latest rmware le by comparing to the ver
sion stated on www.ced7000pro.com
Data Transfer
You can create an IPSC match/training session or a
Steel-Challenge match/training session using www.
ced7000pro.com. The data transfer allows you to easily
download or upload the data to and from your timer.
Export:
1. On the Timer: select Menu -> Export/Import and
click Export. The Export process may take up to 60
seconds to complete
2. Connect the timer to the PC using the mini USB cable
3. Ensure Status on PC application shows “Ready”
4. Click Export Data From Timer
5. Choose the folder you wish to save the le in and
click Save
6. On www.ced7000pro.com click the relevant upload
button and locate your previously saved le
7. Click the safely un-plug button upon nish
Import:
1. Connect the timer to the PC using the mini USB cable
2. Ensure Status is Ready
30