Cedar CD-10M - User Manual

OPERATION MANUAL
TORQUE TESTER
MODEL CD-100M/10M
1571

Summary

Safety Precautions

Warnings

Precautionary statements regarding potential injury or death from mishandling.

Specification

2.1 The name of each part, and the main uses

Identifies and explains the main functions of various parts of the tester.

2.2 Specification

Details technical specifications like model, ranges, accuracy, display, and modes.

Preparation of Measurement

3.1 Measurement Mode

Explains the various measurement modes available on the torque tester.

3.1.1 Kind in Measurement Mode

Details the types of measurement modes: P-P, P-D, C, T-R.

3.1.2 A setup and change in measurement mode

3.1.3 Setup and Change of Measurement Unit

3.3 Cautions at Time of Installation

3.4 Power Source

3.5 About zero adjustment

Measuring Method

4.1 Measurement of Electric Driver

Details the procedure for measuring the torque of an electric driver.

4.1.1 Check of Torque, and Selection of Measurement Joint

Covers checking the torque range and selecting the correct measurement joint.

4.1.2 The method of measurement

Step-by-step instructions for measuring an electric driver's torque.

4.2 Measurement of Torque Driver Torque Wrench

Explains how to measure the torque of torque drivers and wrenches.

4.2.1 Measurement of a torque driver

Step-by-step guide for measuring a torque driver's output.

4.2.2 Measurement of Torque Wrench

Step-by-step guide for measuring a torque wrench's output.

System Reset

System Reset

Instructions for resetting the tester to its initial state.

Calibration Trust Service

8.1 Periodical calibration

8.3 When Troubled

Provides troubleshooting steps for common functional faults and issues.

Cedar CD-10M Specifications

General

Brand	Cedar
Model	CD-10M
Category	Test Equipment
Language	English