What to do if my Cedima Cutter has no power and the blade is blunt?
If your Cedima Cutter experiences no power when cutting and the saw blade is blunt, it could be due to using an inappropriate saw blade for the material. Use the correct saw blade. Alternatively, the saw blade might be inappropriate for the machine power, in which case you should sharpen the diamond saw blade.
What causes too high wear on a Cedima CF-12.4 E-TR Cutter?
If your Cedima Cutter experiences too high wear, consider these possible causes: you might be using the wrong choice of saw blade type, so use harder saw blades. Deviation of the cutting shaft can also be a factor, so renew the bearings. Overheating is another potential cause, ensure adequate water supply.
Why are there cracks in the steel core of my Cedima CF-12.4 E-TR Cutter?
If you find cracks in the steel core of your Cedima Cutter, it could be due to several reasons. The saw blade might be too hard, so use a suitable softer saw blade. The receptacle of the cutting shaft might be worn, have the cutting shaft replaced. Also, there might be too much clearance in the bearings of the cutting shaft, replace or have replaced the bearings.
To Next Page
General
