Cedima CF 13.3 B - Page 47

47
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Maintenance and care
CF•13.3 B / CF•13.3 B-L
ENGLISH
6.7.4 Preparing the joint cutter for further
motor maintenance
as here demonstrated on the CF•13.2 B
For further engine maintenance, dismount the water
container (section 4.9.2)!
Dismount the heat bae plate:
DANGER
Risk of pinching or crushing when mounting/
dismounting the heat bae plate!
Careful with hands and ngers!
DANGER
Risk of burns! Some engine parts will be very
hot in operation and cool down slowly after
stopping the engine!
Let the heat bae plate cool down!
1. Dismount the water container and the rubber strap (sec-
tion 4.9.2, gure 6.25).
Water container and rubber strap dismounted Figure 6.25
2. Loosen and remove the fastening screw at the heat baf-
e plate.
3. Press the heat bae plate down from the frame of the
CF•13.3B / CF•13.3B-L (gures 6.25 and 6.26),
Heat discharger plate, water container dismounted Figure 6.27
Heat bae plate pressed away from the frame Figure 6.26
4. Carefully pull out the heat bae plate between frame
and engine (gures 6.26 and 6.27).
To protect the water container, mount the heat bae
plate immediately again!
When mounting the heat bae plate, pay attention to
the position at the CF•13.3B / CF•13.3B-L frame!