Cedima CF 13.3 B - Page 49

49
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Transport and storage
CF•13.3 B / CF•13.3 B-L
ENGLISH
DANGER
Risk of pinching or crushing when
pushing in the handle!
Careful with hands and ngers!
• Check all connection and attachment elements/modules
before and after transport for rm and correct seat.
ATTENTION
After transport, check the components of the CF•13.3 B /
CF•13.3B-L for transport damage!
7.2 Longer periods of
non-service/storage
• Observe the maintenance intervals and perform mainte-
nance work,
• Observe the previously mentioned issues about trans-
port (section 7.1),
• Release the V-ribbed belt,
• Turn the cutting shaft (engine) approx. monthly (by
hand) for some revolutions,
• Run the functions of the joint cutter approx. monthly,
• Unload the wheels (e.g. with wood under the frame),
• Check all screws and components for safe and secure
seating.
The storage location is:
– not accessible for unauthorised persons,
– dry, frost-free, dust-protected,
– protected from extreme sunlight,
– protected from extreme temperatures or temperature
uctuations,
– protected from extreme vibrations,
– protected from other negative physical and chemical
impact!
Lashing options at the push handle tubes Figure 7.4
Swivel the front visor upward during transport and arrest the detent
pin Figure 7.3
Handle pushed in Figure 7.5
Handle pulled out Figure 7.6