Cedima CF 13.3 B - Page 50

50
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
What if . . .?
CF•13.3 B / CF•13.3 B-L
ENGLISH
8.0 Troubleshooting at the joint cutter CF•13.3 B / CF•13.3B-L
8.1 Problems with the engine
Problem Possible cause Remedy
Engine does not start Fuel tank empty
Cutting shaft blocked,
cutting shaft with saw blade not lifted from the ground
or out of the cut, respectively
Operating lever not in Start position
Emergency-stop button not released
Engine defective
Fill up fuel
Check cutting shaft for free movement
Lift cutting shaft (saw blade) from the ground / out of
the cut
Move operating lever to Start position
Release emergency-stop button
check, repair or replace engine if necessary
No power during cutting,
engine stops
V-ribbed belt slips
V-ribbed belt defective (torn)
Cutting pressure too high
Tension V-ribbed belt
Replace V-ribbed belt
Reduce cutting pressure (feed, cutting depth)!
Observe the operating manual of the engine!
In case of further diculties or defects observe the engine operating manual delivered by the manufacturer or contact
CEDIMA® or a qualied work shop!
All works and repairs on the petrol-engine must only be performed by an authorized qualied work-shop or directly by CEDIMA®.