CEL-FI Go Quick Start Guides

Install Service Antenna
2
For best performance make sure there is 50cm of metal around
the base of the antenna.
Mount your Donor Antenna on the exterior of the vehicle, towards
the rear, according to its design, and the type of vehicle it’s being
used with. Make sure you consider the cable connection to the
Cel-Fi GO unit with your location choice.
Install Service Antenna in the cab, towards the front, where
coverage is needed. Ideally, there should be substantial material,
like the metal of the roof, between the Donor and Service
Antennas, to improve isolation.
DONOR ANTENNA (Not Included)
SERVICE ANTENNA
(Not Included)
Cel-Fi GO is an evolved cellular smart signal booster design
that can amplify cellular signals up to 70 dB. Connect a single
Donor Antenna to receive the macro-network signals, and then
a single indoor Service Antenna where you need service, and
Cel-Fi GO will do the rest automatically.
Install Donor Antenna
I
MOBILE VERSION
DONOR ANTENNA
Cel-Fi GO
Quick Start Guide
Smart Signal Booster
™

CEL-FI Go Specifications

General

Category	Extender
Model	CEL-FI Go
Gain	Up to 100 dB
Coverage Area	Up to 15, 000 sq ft
Power	12V DC
Operating Temperature	-20° to 60° C
Frequency Bands	700 MHz, 850 MHz, 1900 MHz, 2100 MHz