CEL-FI Go - User Manual

For best performance make sure there is 50cm of metal plane
around the base of the antenna.
I
CEL-FI GO QUICK START GUIDE
CEL-FI GO is an evolved Mobile Signal Repeater design
that can amplify mobile signals up to 70 dB.Connect a single
Outdoor Antenna to receive the mobile-network signals, and
then a single Indoor Antenna where you need service, and
CEL-FI GO will do the rest automatically.
Mount your Outdoor Antenna on the exterior of the vehicle,
towards the rear, according to its design, and the type of vehicle
it’s being used with. Make sure you consider the cable connection
to the CEL-FI GO unit with your location choice.
2
Install Outdoor Antenna
Install Indoor Antenna
Install Indoor Antenna in the cab, towards the front, where
coverage is needed. Ideally, there should be substantial
material, like the metal of the roof, between the Outdoor and
Indoor Antennas, to improve isolation.
SMART SIGNAL REPEATER www.Cel-Fi.com.au
MOBILE VERSION
OUTDOOR ANTENNA
INDOOR ANTENNA
qsg_GO-Powertec-mobile-ENG_16-0111
OUTDOOR ANTENNA
Smart Signal Repeater

Summary

Install Outdoor Antenna

Outdoor Antenna Placement

Mount the outdoor antenna on the vehicle exterior, considering design and vehicle type.

Install Indoor Antenna

Indoor Antenna Placement

Install the indoor antenna in the cab where coverage is needed, ideally with roof metal for isolation.

Mount CEL-FI GO Unit

Mounting Location Criteria

Find a location with airflow, safe from objects, and within 12V power supply range.

Connect Antennas to CEL-FI GO

Antenna Connector Identification

Identify the right side for the outdoor antenna and the left side for the indoor antenna connectors.

Plug In and Select Mode

Mode Selection

Press the MODE button to select scanning mode; Status Indicator blinks during setup.

CEL-FI WAVE App Usage

Optionally use the CEL-FI WAVE app for mode selection and setup via smartphone.

Tips & Tricks

Antenna Isolation

Keep indoor and outdoor antennas separated for best performance and short cable runs.

CEL-FI WAVE App

CEL-FI Go Specifications

General

Category	Extender
Model	CEL-FI Go
Gain	Up to 100 dB
Coverage Area	Up to 15, 000 sq ft
Power	12V DC
Operating Temperature	-20° to 60° C
Frequency Bands	700 MHz, 850 MHz, 1900 MHz, 2100 MHz