CEL Power 8 Workshop - Spirit Level and Protractor

Warning: Do not install the circular saw or
jigsaw into the lid of the case before starting the
assemble of the table light.
NOTE: Never leave the table light on
unattended. Turn power OFF the power by
pressing the RED Button on the charger dock.
Switch off the table light and replace the battery
if the light becomes The battery
should be placed on charge.
1. Refer to ‘11.3 Drill Press - Operating
Instructions’ section 1 - 2 for installing the post to
the case.
2. Slide the table light head up into the mating
faces on the front of the post until you hear a
‘click’.
noticeably dim.
Table Light - Specifications
13.1
Table Light - Operating Instructions
Specifications
Voltage: 18V
Bulb: 2 x 18v 0.6A Halogen
Bulb Life: 300 hours
3. Switch ON the light by pressing green button
and switch OFF the light by pressing red button.
o
Rotate the Halogen Light Head
To swivel the head of the halogen light, simply
move it up and down as require. Continue to
adjust the light until it meets your requirements.
NOTE: The flashing function of the halogen light
is disabled when fitted to the post.
n the charger dock.
14. Spirit Level and Protractor
Post
Light Head
On/Off
POWERhandle
13.2