4.2 Unpacking the appliance
WARNING! DO NOT USE THIS APPLIANCE IF ANY PART HAS
BEEN UNDER WATER. IMMEDIATELY CALL A QUALIFIED
SERVICE TECHNICIAN TO INSPECT AND TO REPLACE ANY PART
OF THE ELECTRICAL SYSTEM IF NECESSARY
Open the packaging carefully and remove the foam.
Remove and discard the plastic bag.
Be responsible when handling the packing materials.
Keep the original packaging for future transportation and/or storage.
Check all accessories are removed from the packaging before storing it away for
future use.
KEEP PLASTIC WRAPPING AWAY FROM CHILDREN
4.3 Locating your electric heater
This appliance may be installed virtually anywhere in your home. However, when choosing
a location please ensure that the general instructions are followed. For best results, install
out of direct sunlight.
Make sure that the plug or fused spur is accessible after the electric fire is fitted.
Before connecting the appliance make sure that its rating corresponds to that of the mains
supply and the fuse is the correct rating.
The appliance should be located close to a suitable mains socket-outlet to enable
connection. The electrical socket-outlet must be easily accessible to allow disconnection.
NOTE: the appliance is fitted with an inlet plug and socket underneath the right
side of the casing. Always make sure that it is fully pushed in and secure before
operating the fire. Damage could occur if it is not fitted properly.
WARNING! KEEP DRAPERY AND OTHER FURNISHINGS AT LEAST
3’/0.9M FROM THE FRONT AND SIDES OF THE ELECTRIC HEATER
To Next Page
Loading...