Why does the turntable on my CEMB Tyre Changer not rotate?
If the turntable on your CEMB Tyre Changer isn't rotating, there could be several reasons: * The belt might be broken and needs replacement. * The reverser could be defective, requiring a replacement. * There might be a problem with the motor. Check for any loose wires in the motor, plug, or socket. * In some cases, the motor itself might need to be replaced.
What to do if bead breaking operation is difficult on CEMB Tyre Changers?
If you're finding the bead breaking operation difficult on your CEMB Tyre Changer, consider these potential causes: * A clogged silencer, in which case you should clean or replace it. * A broken bead breaker cylinder gasket, which would require replacing the gasket.
How to fix a slow clamp on a CEMB Tyre Changer?
If the clamp on your CEMB Tyre Changer is slow to open or close, the silencer might be clogged. Try cleaning or replacing it.
What causes a CEMB Tyre Changer turntable to not lock the wheel rim correctly?
If the turntable on your CEMB Tyre Changer isn't locking the wheel rim correctly, it could be due to worn clamps, which would need replacing. Alternatively, the turntable cylinder(s) might be defective, requiring you to replace the cylinder gasket.
Why does the tool touch the rim during tire operations on CEMB Tyre Changers?
If the tool is touching the rim during tire removal or mounting on your CEMB Tyre Changer, it might be because the locking plate is incorrectly adjusted or defective, in which case you should adjust or replace it. Another possibility is a loose turntable locking screw, which needs to be tightened.
What causes a CEMB Tyre Changer turntable to rotate only in one direction?
If the turntable on your CEMB Tyre Changer only rotates in one direction, the reverser is likely broken and needs to be replaced.
Why does the turntable lock on my CEMB Tyre Changer?
If the turntable locks on your CEMB Tyre Changer, it might be due to a loose belt. Try to adjust the belt tension.
What to do if the pedal lock is out of working position on a CEMB Tyre Changer?
If the pedal lock on your CEMB Tyre Changer is out of working position, the return spring is likely broken and needs to be replaced.
General| Brand | CEMB |
|---|---|
| Model | SM825 |
| Category | Tyre Changers |
| Language | English |
To Next Page
