CEMB SM825 - Troubleshooting

REV. 01 24 / 28
CHAPTER 8 – TROUBLE-SHOOTING
T ROUBLE : P OSSIBLE C AUSE : S OLUTION :
Turntable rotates only in
one direction.
Reverser broken Replace reverser
Turntable does not rotate.
Belt broken Replace
Reverser broken Replace reverser
Problem with motor
Check for loose wire in the
motor, plug or socket.
Replace motor
Turntable locks Belt loose
Adjust the belt tension (chap. 7
Fig. 24)
Clamp slow to open or
close
Silencer clogged Clean or replace silencer
Turntable does not lock
the wheel rim correctly
Clamps worn Replace clamps
Turntable cylinder(s) defective Replace cylinder gasket
The tool touches the rim
during the tire removing
or mounting operations
Locking plate incorrectly adjusted or
defective
Adjust or replace locking plate
(chap 7 – Fig 25)
Turntable locking screw loose Tighten screw
Pedal lock out of
working position
Return spring broken Replace spring
Bead breaking operation
difficult
Silencer clogged
Clean or replace silencer (chap 7
– Fig. 27)
Bead breaker cylinder gasket broken Replace gasket