Center 370 - 0 °C Calibration

RTD THERMOMETER
10
6.2 0 °C Calibration
Insert temperature probe into 0°C Deg.
Standard calibration unit before calibration.
Hold the probe until condition is stabilized
before starting calibration.
6-2-1.
Press and hold “Power” + “Light” buttons for
2 seconds to enter setup mode.
6-2-2.
Press “REL” button to enter calibration
mode. Enter PT selection first.
6-2-3.
Press “°C/°F” button to confirm PT selection
.
6-2-4.
Press “REL” button to enter calibration
mode.