SPECIFICATIONS
Motor:
Spindle Speeds:
Distance Between Centers:
Swing Over Bed:
Tail Stock Quill:
Sanding Disc:
Disc Table:
Overall Dimensions:
112HP, 115V,60Hz, 1790 RPM; 18.2 amps under load
1125, 1640,2360,
&
3450 RPM
40"
14"
3-112" Travel; MT2 Taper
7"
112"Miter Gauge Slot; 7-112"x 5" overall size
63-3/4"
x
11"
x
15"
SAVE THIS MANUAL
You will need this manual for the safety instructions, assembly instructions, operating
procedures, parts list, and diagram. Write your invoice number on the inside front cover. Put both
your manual and invoice in a safe, dry place for future reference.
IMPORTANT SAFETY PRECAUTIONS
WARNING:When using electric tools, machines or equipment, basic safety precautions
should always be followed to reduce the risk of fire, electric shock, and personal injury.
READALL INSTRUCTIONS BEFORE USING THIS TOOL
1. KEEP WORK AREACLEAN. Cluttered areas invite injuries.
2.
CONSIDER WORK AREACONDITIONS. Don't use tool in damp, wet, or poorly lit locations.
Don't expose to rain. Keep work area well lit. Don't use tools in the presence of flammable gases or
liquids.
3. KEEP CHILDREN AWAY.All children should be kept away from the work area. Don't let them
handle tool or extension cords.
4. STORE IDLE EQUIPMENT.When not in use, tool should be locked up in a dry location to
inhibit rust. If possible, store in an area out of reach of children.
5.
DON'T FORCE THE TOOL. It will do the job better and more safely at the rate for which it was
intended.
6.
USE THE RIGHT TOOL. Don't force a small tool or attachment to do the work of a larger
industrial tool. Don't use a tool for a purpose for which it was not intended.
7. DRESS PROPERLY.Don't wear loose clothing or jewelry. They can be caught in moving parts.
Protective, electrically non-conductive gloves and non-skid footwear are recommended when
working, Wear protective hair covering to contain long hair, preventing it from getting caught in
machinery.
8.
USE EYE AND EAR PROTECTION. Use a full face mask if the work you're doing produces metal
filings, dust or wood chips. Goggles are acceptable in other situations. Wear a clean dust mask if
the work creates a lot of fine or coarse dust. When operating for extended periods of time, use
approved ear protection. Face masks, dust masks, safety goggles and ear protectors are available
from Harbor Freight Tools.
9.
DON'T
ABUSE THE POWER CORD. Do not yank it to disconnect it from receptacle. Do not
move bench-mounted or floor-standing machines with the power cord in the outlet. Keep cord
2
To Next Page
Loading...
