To Next PageTo Next PageWhy does my Central Machinery 44846 bit burn or smoke?
Your Central Machinery Drill bit may burn or smoke due to several reasons: the spindle speed might be incorrect (change the spindle speed), the drill bit could be dull (replace with a new bit), you might be drilling too slowly (drill faster), or the cutting area may lack lubrication (lubricate cutting area).
What to do if my Central Machinery 44846 makes unusual noise?
If your Central Machinery Drill is making unusual noises, it could be due to several factors. The belt tension might be set incorrectly (adjust belt tension), the spindle may be dry (lubricate spindle), the spindle pulley might be loose (check pulley nut), or the motor pulley could be loose (tighten set screws).
How to fix a Central Machinery 44846 Drill bit that wobbles?
If your Central Machinery Drill bit wobbles, possible causes include a bent bit (replace drill bit), worn spindle bearings (replace spindle bearings), the drill bit not being correctly installed in the chuck (reinstall drill bit), or the chuck not being properly installed (reinstall chuck and arbor assembly).
What to do if the Feed Wheel returns slowly or too fast on my Central Machinery Drill?
The Tension Spring may not be adjusted properly. Adjust the Tension Spring.
General| Chuck Size | 1/2 inch |
|---|---|
| Voltage | 120V |
| Spindle Taper | JT33 |
| Table Tilt | 45° |
| Type | Floor |
| Swing | 12 inch |
| Spindle Travel | 3-1/8 inch |
| Table Size | 9-1/2 in. |
Essential safety rules for work area, personal protection, and tool storage.
Step-by-step guide for drilling holes using the drill press.
Instructions for changing the angle of the drill press head.
Guide for removing, installing, and adjusting the chuck and spindle shaft.
Steps for adjusting the spring tension for the feed wheel return.
