To Next PageTo Next PageWhy is the blade not in line with the arm motion on my Central Machinery 93012 Saw?
If the blade is not in line with the arm motion on your Central Machinery Saw, it is because the blade holders are not aligned. To fix this, loosen the hex bolts and realign the upper and lower blade holders, then tighten the hex bolts.
Why does the performance of my Central Machinery 93012 decrease over time?
If the performance of your Central Machinery Saw decreases over time, keep cutting accessories sharp and replace them as needed. Additionally, have a qualified technician replace the brushes.
Why does my Central Machinery 93012 Saw have excessive noise or rattling?
If your Central Machinery Saw has excessive noise or rattling, it may be due to internal damage or wear, such as with the carbon brushes or bearings. Have a technician service the tool.
Why are the blades breaking on my Central Machinery Saw?
If the blades of your Central Machinery Saw are breaking, it could be due to several reasons. First, adjust the blade tension. Second, reduce the feed cut rate. Third, use narrow blades for cutting thin wood and wide blades for cutting thicker wood. Finally, avoid side pressure on the blade, as twisting in the wood can also cause breakage.
General| Brand | Central Machinery |
|---|---|
| Model | 93012 |
| Category | Saw |
| Language | English |
