Central Machinery 97181 User Manual (English)

Other manuals for Central Machinery 97181

Questions and Answers:

K
Kathleen MooreJul 30, 2025
What to do if my Central Machinery Sander does not turn on?
- D
  David MyersJul 30, 2025
  If your Central Machinery Sander doesn't turn on, there are several possible causes: * It might not be plugged in, so ensure the sander is properly plugged into an outlet. * There may be no power at the outlet. Check the outlet and circuit breaker. * The orange plastic key may not be inserted into the magnetic switch. Insert the key into the magnetic switch. * The switch might not be turned on. Make sure to turn the switch to the “ON” position.
C
Chelsea WilliamsAug 5, 2025
Why does wood burn while sanding with my Central Machinery 97181?
- D
  Dawn PerryAug 5, 2025
  Wood burns during sanding with your Central Machinery Sander for two primary reasons: 1. The sanding disc or belt could be loaded with dirt or debris. Clean or replace the disc or belt following the instructions in this manual. 2. You might be applying too much pressure. Reduce the amount of pressure you're using while sanding.
L
Laura HunterAug 10, 2025
What to do if the motor slows when sanding with Central Machinery Sander?
- K
  Karen ReyesAug 10, 2025
  If the motor of your Central Machinery Sander slows down during sanding, it could be due to: 1. A V-belt that is too tight. Have a qualified technician adjust the V-belt. 2. Applying too much pressure while sanding. Try using less pressure to see if this resolves the issue.
A
Andrew ClarkAug 16, 2025
What to do if my Central Machinery 97181 Sander motor slows down when sanding?
- S
  sgriffinAug 16, 2025
  If the motor slows down while sanding with your Central Machinery Sander, it may be due to a V-belt that is too tight (in this case, have the V-Belt adjusted by a qualified technician) or applying too much pressure while sanding (in this case, use less pressure).
B
brenda84Aug 23, 2025
Why does wood burn when sanding with my Central Machinery Sander?
- K
  Kelly KaneAug 23, 2025
  If wood burns while sanding with your Central Machinery Sander, it could be due to the sanding disc or belt being loaded with dirt or debris (clean or replace the disc or belt using instructions in this manual) or too much pressure being applied (use less pressure).