Central Machinery 43468 User Manual

DISC SANDER - 12 INCH
43468
SET UP AND OPERATING INSTRUCTIONS
Distributed exclusively by Harbor Freight Tools
®
.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Copyright
©
2000 by Harbor Freight Tools
®
. All rights reserved. No portion of this manual or any artwork
contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight
Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual
product may differ slightly from the product described herein. Tools required for assembly and service may not
be included.
For technical questions or replacement parts, please call 1-800-444-3353.
Cover Revised 09b

Central Machinery 43468 Specifications

General

Type	Belt and Disc Sander
Disc Speed	3450 RPM
Motor	1/2 HP
Voltage	120V
Belt Size	4 x 36 inches
Disc Diameter	6 inches
Table Tilt	0 to 45 degrees
Amps	4.3 amps

Summary

Specifications

Safety Warnings and Precautions

General Work Area and Personal Safety

Covers clean area, conditions, children, storage, tool use, and attire.

Operational Safety Guidelines

Personal Protection and Machine Operation

Details eye/ear protection, balance, maintenance, power disconnect, and avoiding hazards.

Health Warnings and Usage Conditions

California Prop 65 and Pacemaker Safety

Addresses California chemical warnings, lead exposure, and pacemaker use.

Unpacking and Parts Check

Installation Steps

Initial Setup and Connection

Guide to setting up the sander, mounting the pad, and connecting to power.

Operation

Leveling the Work Table

Instructions on how to ensure the work table is perpendicular to the sanding pad.

Adjusting Table Angle

Procedure for tilting the work table to specific angles for sanding.

Replacing the Sanding Pad

Steps to remove the old sanding pad and install a new one.

ON/OFF Safety Switch

Maintenance

Cleaning and Storage

Guidance on applying wax, using compressed air, and proper storage.

Parts List

Assembly Drawing