SKU 43468 For technical questions, please call 1-800-444-3353. Page 4
Unpacking
When unpacking, check to make sure the following parts are included.
Parts should include: Disc Sander unit with Work Table, Mitre Gauge, Key Switch, and
three 12-inch sanding discs.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
Installation
Set the Disc Sander on a sturdy work bench. Optionally, the Rubber Pads (50) can be 1.
removed and the Disc Sander Base (49) can be permanently bolted to the bench.
Mount the Sanding Pad (1). See page 5 for instructions.2.
Place the Mitre Gauge on the Work Table (46).3.
Insert the Plug (73) into an electrical outlet with a minimum current capability of 20 4.
amps.
age to the tool. This tool requires use of an extension cord of 0 to 20 amps capability
(up to 50 feet), with wire size rated at 14 AWG. Longer extension cords require larger
size wire. If you are using the tool outdoors, use an extension cord rated for outdoor
use (signied by “WA” on the jacket).
People with pacemakers should consult their physician(s) before use. Electromag-23.
netic elds in close proximity to heart pacemaker could cause pacemaker interference
or pacemaker failure.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other 24.
construction activities, contains chemicals known [to the State of California] to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals
are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement or other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially de-
signed to lter out microscopic particles. (California Health & Safety Code § 25249.5,
et seq.)
WARNING: Handling the cord on this product will expose you to lead, a chemical 25.
known to the State of California to cause cancer, and birth defects or other reproduc-
tive harm. Wash hands after handling. (California Health & Safety Code § 25249.5, et
seq.)
The warnings, cautions, and instructions discussed in this instruction manual 26.
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
REV 09b
To Next Page