Central Machinery T34706 - Assembly; Unpacking and Parts Verification

VI. Assembly
Unpacking (figure 1)
1. Carefully remove the leg set and wood lathe from the carton.
CAUTION: THE WOOD LATHE IS VERY HEAVY AND MUST BE LIFTED WITH THE
HELP OF 2 PEOPLE OR MORE. THE ASSEMBLY PROCESS REQUIRES 2 PEOPLE OR
MORE TO SAFELY ASSEMBLE THE LATHE TO THE LEG SET.
2. Separate the parts for the leg set from the parts of the lathe.
3. Lay out all parts and check them against the parts listed below. Examine all parts carefully.
WARNING: IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG THE WOOD
LATHE IN UNTIL YOU HAVE REPLACED THE MISSING OR DAMAGED PART.
For your safety, complete the assembly of the lathe before plugging it into the power supply.
Lathe bed assembly
P="
m
Faceplate Spindie handle
w/spring & screw
a.
EGEN
e
Wr
>
==
[&
€
- 4 hex keys
3,4,6,8 mm Tallstock cup center 2 - 32mm flat wrenches 24 carrlage bolts 8 hex bolts
2 long leg supports
2 front legs & 2 rear legs 2 top leg plates