Central Machinery T34706 - Stand and Lathe Bed Assembly

Vi. Assembly
Fe the leg set (Figure 2)
. Attach one front and one back leg [1] to the
outside edge of the top plate [2] using
carriage bolts [3], washers [4], and nuts [5].
. Position the top plate so that it fits inside the legs.
. Repeat step 1 for the opposite side.
. Attach long supports [6] to legs using
carriage bolts, washers and nuts.
5. Attach short supports (7] to legs using
carriage bolts, washers, and nuts.
6. Place the stand on a level surface and tighten
all nuts securely using a 14 mm wrench or
adjustable wrench.
A OP
SC the lathe on the leg set (Figure 3)
. Place the lathe bed assembly [1] on the leg set.
a Position the headstock [2] assembly over the
top plate and align the holes in the bed [3]
with the holes in the top plate [4]. Set the
headstock down carefully.
3. Align tho tailstock assembly end of the lathe
over the top plate mounting holes and set it
down carefully.
4. Insert the hex bolts [5] into the mounting
holes in each bed and into the top plate.
5. Thread washer [6] and nut [7] onto bolt [5],
and tighten securely.
IMPORTANT:
THE
LEG
SET
MUST
BE
FASTENED
TO
THE
SUPPORTING
SURFACE.
Head lock handle (Figure 4)
1. Locate and assemble the head locking
handle [1], spring [2] and bolt [3] as shown.
2. Thread assembled handle into the head
locking Clamp [4] and tighten.
NOTE: Spring loaded handles
The spring loaded handles on the lathe
are designed to minimize interference with other
lathe parts or the workpiece.To operate,
push the handle lever in and turn clockwise to
tighten. Releasing the handle lever will
disengage the threaded shaft, allowing you to
reposition the lever handie so it is out of the way.