Central Machinery T34706 - Component Installation

Spurs
1.
Faceplate (Figure 7)
1.
2.
3.
Extension bed (Figure 8)
1.
.
Insert
the
headstock
spur
[3]
in
the
spindle
hole.
. Insert
the
tailstock
center
[4]
in
the
. To remove either the headstock spur or the
. H outboard faceplate turning does not
. To attach the extension bed [1] to the bed,
Vi. Assembly
Remove the faceplate [1] from the headstock
spindle using the two wrenches provided [2]
to
separate
the
faceplate
from
the
epindle
nut.
(Figure 5)
tailstock hole. (Figure 6)
tailstock center, insert the push-out rod [5]
into the hole [6] at the opposite end of the
headstock or tailstock. Remove and store the
rod in a safe location after use.
Remove the headstock spur from the spindle.
Thread the 4 inch diameter faceplate to the
spindle.
Mount the workpiece to the faceplate with the
flat head brass wood screws. Make sure the
length of the screws does not interfere with
the cutting tools.
The extension bed is attached to the left of
the headstock for outboard faceplate turning
when the use of the tool rest is required.
require the use of the tool rest, do not attach
the extension bed until needed.
align the bolt holes [2] with the threaded bed
holes [3]. Put the lock washer [4] on the hex
bolt [5]. First finger tighten the hex bolt, then
secure the hex bolt with the hex key provided.
WARNING:
DO
NOT
OPERATE
YOUR
WOOD
LATHE
UNTIL
IT
IS
COMPLETELY
ASSEMBLED
AND
ADJUSTED
ACCORDING
TO
THE
INSTRUCTIONS.