Central Pneumatic 65902 - Post-Operation Procedures; Shutdown, Cleaning, and Storage; User Maintenance Instructions; Maintenance Safety Warnings

SKU 65902/66742 For technical questions, please call 1-800-444-3353. Page 12
pressure in the Soda Blaster, and
release the throttle and/or turn the
switch to its off position after use.
Clean external surfaces of the Soda
Blaster with clean, dry cloth, and
apply a thin coat of Soda Blaster oil.
Then store the Soda Blaster indoors
out of children’s reach.
When work is completed, release the 11.
trigger to stop blasting. Turn off the air
pressure supply. Clean up all materi-
als and store your Soda Blaster safely
and securely.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM
ACCIDENTAL OPERATION:
Turn off the Soda Blaster,
detach the air supply, safely
discharge any residual air
pressure in the Soda Blaster,
and release the throttle and/or
turn the switch to its off
position before performing
any inspection, maintenance,
or cleaning procedures.
TO PREVENT SERIOUS
INJURY FROM SODA
BLASTER FAILURE:
Do not use damaged
equipment. If abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
Cleaning and Maintenance
Note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular
operation of the air-operated Soda
Blaster.
Daily - Air Supply Maintenance: 1.
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers’ instructions.
Performing routine maintenance on
the air supply will allow the Soda
Blaster to operate more safely and
will also reduce wear on the Soda
Blaster.
Separated moisture from supplied 2.
air will automatically drip from bot-
tom of the lter. At the end of each
project/daily, pull down on the bibbed
outlet underneath the lter. This will
allow discharge of possibility trapped
small particles. If the valve gets
stuck or debris and moisture remain
trapped in the cup, noting orienta-
tion of the cup, push in the red lock
release and twist and remove the
lter. Clean the cup and valve and
re-attach.
Quarterly (every 3 months) - Soda 3.
Blaster Disassembly, Cleaning,
and Inspection:
Have the internal mechanism cleaned
and inspected, by a qualied techni-
cian.