SKU 65902/66742 For technical questions, please call 1-800-444-3353. Page 7
FUNCTIONAL DESCRIPTION
Specications
Model
65902
Model
66742
Recommended Air
Pressure Range
35-90 PSI
Maximum Air Pressure 100 PSI
Air Inlet 1/4” -18 NPT
Air Consumption @ 90 PSI
12.5
SCFM
7 SCFM
Media Capacity 10 lbs. 15 lbs.
Media Type
Sodium Bicarbonate
(Baking Soda)
INITIAL SODA BLASTER
SET UP AND ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
This air Soda Blaster may be •
shipped with a protective plug cov-
ering the air inlet. Remove this plug
before set up.
Components and Controls
Please refer to illustrations and parts
list on pages 14-15 to identify important
components and controls of this tool.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
Soda Blaster. Do not use
oxygen, carbon dioxide,
combustible gases, or any
other bottled gas as a power
source for this Soda Blaster.
1. Incorporate an in-line lter, shut-off
valve and regulator with pressure
gauge for best service, as shown in
the diagram above. An in-line shut-
off valve is an important safety
device because it controls the air
supply even if the air hose is rup-
tured.
Attach an air hose to the compres-2.
sor’s air outlet. Connect the air hose
to the Male Coupler of the Soda
REV 09e
To Next Page
Loading...
