Central Pneumatic 65902 - Service and Air Source Requirements; Air Source Specifications

SKU 65902/66742 For technical questions, please call 1-800-444-3353. Page 4
Store the Soda Blaster when it is e.
idle out of reach of children and
other untrained persons. A Soda
Blaster is dangerous in the hands of
untrained users.
Maintain the Soda Blaster with f.
care. A properly maintained tool re-
duces the risk of binding and is easier
to control.
Check for misalignment or bind-g.
ing of moving parts, breakage of
parts, and any other condition
that affects the Soda Blaster’s
operation. If damaged, have the
Soda Blaster serviced before using.
Many accidents are caused by poorly
maintained Soda Blasters. There is a
risk of bursting if the Soda Blaster is
damaged.
Use only accessories that are h.
identied by the manufacturer for
the specic Soda Blaster model.
Use of an accessory not intended for
use with the specic Soda Blaster
model, increases the risk of injury to
persons.
Service
Soda Blaster service must be a.
performed only by qualied repair
personnel.
When servicing a Soda Blaster, b.
use only identical replacement
parts. Use only authorized parts.
Air Source
a. Never connect to an air
source that is capable of
exceeding 100 psi. Over
pressurizing the Soda
Blaster may cause burst-
ing, abnormal operation, breakage of
the Soda Blaster or serious injury to
persons. Use only clean, dry, regu-
lated compressed air at the rated
pressure or within the rated pressure
range as marked on the Soda Blast-
er. Always verify prior to using the
Soda Blaster that the air source has
been adjusted to the rated air pres-
sure or within the rated air-pressure
range.
Never use oxygen, carbon dioxide, b.
combustible gases or any bottled
gas as an air source for the Soda
Blaster. Such gases are capable of
explosion and serious injury to per-
sons.
The warnings and precautions dis-
cussed in this manual cannot cover
all possible conditions and situations
that may occur. It must be under-
stood by the operator that common
sense and caution are factors which
cannot be built into this product, but
must be supplied by the operator.
SAVE THESE
INSTRUCTIONS.
SYMBOLS AND
SPECIFIC SAFETY
INSTRUCTIONS
Symbol Denitions
Symbol Property or Statement
n
o
No-load speed
.../min
Revolutions or reciprocation per
minute
Chart continued in next column.