Central Pneumatic 92917 - Tool Use and Care

Page 4 For technical questions, please call 1-800-444-3353. SKU 92917
93253
Always assume that the tool i.
contains fasteners. Do not point
the tool toward yourself or anyone
whether it contains fasteners or not.
WARNING – Do not re fastener on j.
top of another fastener. This is able
to cause the fastener to be deected
and hit someone, or cause the tool to
react and result in a risk of injury to
persons.
WARNING – Remove nger from k.
the trigger when not driving
fasteners. Never carry the tool with
nger on trigger, the tool is able to re
a fastener.
Tool use and care
Use clamps or another practical a.
way to secure and support the
workpiece to a stable platform.
Holding the work by hand or against
the body is unstable and can lead to
loss of control.
Do not force the tool.b. Use the
correct tool for the application. The
correct tool will do the job better and
safer at the rate for which the tool is
designed.
Do not use the tool if the trigger c.
does not turn the tool on or off.
Any tool that cannot be controlled
with the trigger is dangerous and
must not be used until repaired.
Disconnect the tool from the d.
air source before making
adjustments, doing tool
maintenance, clearing jams,
touching the safety nosepiece,
leaving work area, loading,
or unloading the tool. Such
precautionary measures reduce the
risk of injury to persons.
Store the tool when it is idle out e.
of reach of children and other
untrained persons. A tool is
dangerous in the hands of untrained
users.
Maintain the tool with care.f. A
properly maintained tool reduces
the risk of binding and is easier to
control.
Check for misalignment or binding g.
of moving parts, breakage of
parts, and any other condition
that affects the tool’s operation.
If damaged, have the tool serviced
before using. Many accidents are
caused by poorly maintained tools.
There is a risk of bursting if the tool is
damaged.
Use only accessories that are h.
identied by the manufacturer for
the specic tool model. Use of an
accessory not intended for use with
the specic tool model, increases the
risk of injury to persons.
Use only those fasteners listed i.
in the Specications chart of this
manual. Fasteners not identied
for use with this tool by the tool
manufacturer are able to result in
a risk of injury to persons or tool
damage when used in this tool.
Service
Tool service must be performed a.
only by qualied repair personnel.
When servicing a tool, use only b.
identical replacement parts. Use
only authorized parts.