Page 5For technical questions, please call 1-800-444-3353.SKU 92917
93253
Use only the lubricants supplied c.
with the tool or specied by the
manufacturer.
Air source
a. Never connect to an air
source that is capable of
exceeding 200 PSI. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
Never use oxygen, carbon dioxide, b.
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SAVE THESE
INSTRUCTIONS.
SPECIFIC SAFETY
INSTRUCTIONS
Operators and others in work area 1.
MUST wear ANSI-approved safety
goggles with side shields during
use. The employer is responsible to
enforce the use of eye protection by
the operator and others in the work
area.
Keep ngers away from trigger 2.
when not driving fasteners to
avoid accidental ring.
Choice of triggering method is 3.
important. Check manual for
triggering options.
Always assume the tool contains 4.
fasteners.
Do not point the tool toward yourself 5.
or anyone whether it contains
fasteners or not.
Do not actuate the tool unless the 6.
tool is placed rmly against the
workpiece.
Respect the tool as a working 7.
implement.
No horseplay. This tool is not a toy 8.
and can be deadly if misused.
Do not load the tool with fasteners 9.
when any one of the operating
controls, such as the Trigger or
Safety Nosepiece, is activated.
Do not remove, tamper with, or 10.
otherwise cause the tool operating
controls to become inoperable.
Do not operate the tool if any portion 11.
of the tool operating controls is
inoperable, disconnected, altered, or
not working properly.
Disconnect the tool from the air 12.
supply when:
Unattended.a.
Performing any maintenance or b.
repair.
Clearing a jam.c.
Moving the tool to a new location.d.
Do not make any modications to this 13.
tool.
Refer to the tool maintenance 14.
instructions for detailed information
To Next Page
Loading...
