Central Pneumatic 92917 - Initial Tool Set Up; Assembly

Page 8 For technical questions, please call 1-800-444-3353. SKU 92917
93253
Components and Controls
TRIGGER
(73)
CANISTER
SAFETY
NOSEPIECE
AIR
INLET
Safety Nosepiece - Also called the
workpiece contact, the Safety
Nosepiece helps prevent the tool
from ring unless it is pressed against
an object.
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
This air tool may be shipped with a •
protective plug covering the air inlet.
Remove this plug before set up.
REV 05i; 05l; 07j
FUNCTIONAL DESCRIPTION
Specications
92917 93253
Unit Weight 8 lb. 6 lb.
Housing Material Aluminum Alloy Magnesium
Fastener Length Capacity 3/4” to 1-3/4” Long
Fastener Thickness 0.12” Diameter (Approximately)
Canister Capacity 120 Nails
Operating PSI 70 to 100
Air Consumption 4.5 CFM @ 90 PSI
Triggering Type Full-Sequential Safety Mechanism
Accessories 5 mm Hex Wrench,
Pneumatic Tool Oil,
120 Nails, Carrying Case
5 mm Hex Wrench,
Pneumatic Tool Oil