Central Pneumatic 95498 - PRE-START INSTRUCTIONS

SKU 95498 For technical questions, please call 1-800-444-3353. Page 9
PRE-START INSTRUCTIONS
To Add Compressor Oil:
OIL SIGHT GLASS
(22)
OIL BREATHER CAP
(25)
DESIRED LEVEL
FIGURE E
1. IMPORTANT! Prior to rst using the Compressor, the Compressor MUST be
lled with a high quality S.A.E. 15W-30w grade non-detergent compressor oil.
(See Figure E.)
To do so, 2. unscrew and remove the Oil Breather Cap (25). Pour approximately 1/2
quart of compressor oil into the Oil Breather Cap hole. Do not overll.
(See Figure E.)
Observe the level of compressor oil through the Oil Sight Glass (22). The oil level 3.
should appear between the “MINIMUM” and “MAXIMUM” marks on the Indicator.
(See Figure E.)
If necessary, continue adding compressor oil, while re-checking the Oil Sight Glass 4.
(22). Maintain oil level at the center of indicator in the Oil Sight glass.
When nished adding compressor oil, re-install the Oil Breather Cap (25) back into 5.
the Oil Breather Cap hole.