To Next PageTo Next PageWhy won't my Central Pneumatic 95499 Air Compressor start?
Your Central Pneumatic Air Compressor might not start due to several reasons: a blown fuse or tripped circuit breaker (replace or reset it), loose electrical connections (ensure the compressor is plugged into a working, 120-volt grounded outlet), or bad capacitors (replace the capacitors).
What to do if my Central Pneumatic Air Compressor has low pressure?
If your Central Pneumatic Air Compressor has low pressure, it could be due to a restricted air filter (replace the air filter), a defective check valve (have a qualified service technician replace it), an air leak in the safety valve (check the valve by pulling on the ring; if the condition persists, have a qualified service technician replace the valve), or a defective valve plate (replace the valve plate).
How to stop oil discharge in air from my Central Pneumatic Air Compressor?
Oil discharge in the air from your Central Pneumatic Air Compressor can be caused by too much oil in the crankcase (drain and refill to the proper level), the compressor overheating (reduce air pressure regulation), or a restricted oil breather cap (clean or replace the cap).
Why is the safety valve releasing on my Central Pneumatic 95499?
The safety valve on your Central Pneumatic Air Compressor might be releasing due to a defective pressure switch (have a qualified service technician replace it) or a defective safety valve (replace the safety valve).
What to do if the pressure switch won't turn off my Central Pneumatic 95499?
If the pressure switch won't turn off your Central Pneumatic Air Compressor, immediately unplug the compressor from its electrical outlet and do not operate it until a qualified service technician can replace the pressure switch, as the switch is defective.
General| Type | Portable |
|---|---|
| Tank Capacity | 4 Gallons |
| Max Pressure | 125 PSI |
| Air Delivery | 2.6 SCFM @ 90 PSI |
| Weight | 34.4 lbs. |
| Maximum Pressure | 125 PSI |
| Power | 120V |
| Air Delivery @ 90 PSI | 2.6 SCFM |
| Voltage | 120V |
| Max PSI | 125 PSI |
| SCFM at 90 PSI | 2.6 SCFM |
| HP | 0.8 HP |
Conditions that will void the compressor's warranty, including not using oil or dropping it.
Guidelines for maintaining a safe and well-lit work area, avoiding explosive atmospheres, and keeping bystanders clear.
Precautions for operating the compressor, including tool compatibility, draining, avoiding injury, and environmental warnings.
Explanation of grounding requirements for tools with three-prong plugs and proper outlet connection.
Step-by-step guide to starting the air compressor, including valve positions and pressure settings.
Step-by-step guide on how to safely stop the air compressor.
