Centrometal BioTec-L - Default Chapter; Table of Contents

Technical instructions REGULATION BioTec-L
2
Content
1.0. Description - (4)
1.1. Switching on - (4)
1.2. Main menu - (5)
1.3. Buttons - (5)
1.4. Symbols - (6)
2.0. Configuration (authorized persons only) - (7)
2.1. General connection schemes configuration - (9)
2.1.1. Motor drive opening time - (19)
2.1.1.1. Protection valve - Opening time - (19)
2.1.1.2. Opening time - Motor drive - (20)
3.0. Main menu description - (21)
3.1. Temperatures - (21)
3.1.1. Boiler temperature - (22)
3.1.2. Differential of boiler temperature - (22)
3.1.3. Minimum buffer tank temperature - (22)
3.1.4. Domestic hot water temperature - (23)
3.1.5. Domestic hot water difference - (23)
3.1.*. Min Temp CRO - (23)
3.1.6. Temperatures in heating circuit motor drive - (24)
3.1.6.1. Heating circuit motor drive - (24)
3.1.6.2. Heating curve - (24)
3.1.6.3. Correction coefficien t - (25)
3.1.6.4. Value of day room temperature - (26)
3.1.6.5. Value of night room temperature - (26)
3.1.6.6. Day/night temperature choice - (26)
3.1.6.7. Day/night temperature table - (27)
3.1.6.8. Transition time - (27)
3.1.7. Correct o r - (28)
3.1.7.1. Value of day room temperature - (28)
3.1.7.2. Value of night room temperature - (28)
3.1.7.3. Day/night temperature choicce - (29)
3.1.7.4. Day/night temperature table - (29)
3.2. History - (30)
3.3. File - (31)
3.3.1. Load factory - (31)
3.3.*. Load service - (31)
3.3.2. Save - (31)
3.3.3. Load - (31)
3.4. Operation - (32)
3.4.1. Manual test - (32)
3.4.1.1. Protection valve - (33)
3.4.1.2. Alarm - (34)
3.4.1.3. Lambda - (35)
3.4.2. Chimney sweeper
- (35)
3.4.3. Forced shutdown - (36)
3.4.4. Alarm - (37)
3.4.4.1. Errors - (38)
3.4.4.2. Fuel level - (38)
3.4.4.3. Buffer tank - (39)
3.4.4.4. Delay - (40)
3.4.4.5. Table - (40)
3.4.4.6. Table 1 - (40)
3.4.5. Pump protection - (42)
3.4.6. Internet supervision - (43)
3.5. Date and Time - (45)
3.6. Display - (45)
3.6.1.1. Screensaver - Time - (45)
3.6.1.2. Screensaver - Hold on - (46)