Centurion POLOphone - Handset Wiring and Assembly; Cable Routing and Termination; Connecting the Cradle; Wiring the Status LED

80mm80mm
A
B
1110
CONCEALED
CABLE ROUTE
CONCEALED
CABLE ROUTE
!
Terminate cable onto electronics.
Refer to wiring diagram (See page
10).
!
If the cable is surface mounted,
route the cable into the unit from
underneath as shown. Secure to
cradle base using cable tie provided.
Allow sufficient slack (±80mm)
1413
15
A
!
Using a sharp knife carefully cut out
the cable entry slot to allow the
surface mounted cable to route into
!
Clip the cradle back onto the base.
NB: It will be necessary when
commissioning the unit to have
the cradle cover removed.
!
Clip the (A) long tail end of the
telephone cord into the jack provided
at the bottom of the cradle and
similarly into the handpiece. Replace
the handpiece onto the cradle.
Polophone Intercom - Page 11
HANDSET INSTALLATION
80mm80mm
9
!
Tighten cable tie ensuring that there is
sufficient slack to terminate the cable
onto the electronics (±80mm).
A
B
!
Terminate onto the electronics.
Refer to the wiring diagram (See page
10)
Wiring the status LED Wiring the status LED
1
!
Connect the wires from the status
LED on the gate motor to the
terminals.
12
*
2
!
Insert the wire from the LED drive in
the gate motor into the terminal
marked with a ( ).
!
Insert the wire from the COM/- from
the gate motor into the terminal
marked with a ( ).
*