45
5. Cut Pickets
• Remember to wear safety glasses when cutting
• Use pencil line as guide only — DO NOT CUT ALONG
PENCIL LINE
• Blade should cut approximately 1-1/4 above the line to
allow picket to enter rail
• To practice safety, remove pickets and cut on a flat,
secure surface
6. Picket End Channel
• Cut end channel to length
• Center channel on post between routed holes
• Attach channel to post in four locations
7. Insert Pickets into Bottom Rail
8. Slide Top Rail over Pickets
9. Insert Locking Rings
10. Insert Rail into Post Holes
Curved Rail
Includes: Concave, Convex, "S" Curve and Swoop
To Next Page
