CertainTeed Bufftech - Gate Post and Spacing Guidelines

5
1-1/2"
69-1/2"
70-3/4"
Gate Dimensions
Gate is reinforced
with
a 1.5" galvanized
steel
box tube.
Galvanized steel
wire strand core
3/32"
Gate hinge threads into the
upper and lower inserts in the
gate metal frame leaving
about
1-1/2" from the edge of
the
gate to the gate post.
Gate hinge threads into the
upper and lower inserts in
the gate metal frame leaving
about 1.5" from the edge of
the gate to the gate post.
This still needs work - info/design
All gates require about a 1-1/2" gap between the gate and
the gate post, and about a 1" gap between the gate and
the end post or between the two gates when using double
gates. For a single gate, use one gate post and one end
post. For double gates, use two gate posts.
Gate Post End Post
Inside-to-Inside Post Spacing (see table below)
Gate Width Single Opening
Double Drive
w/3ft. gate
Double Drive
w/4ft. gate
Double Drive
w/5ft. gate
Double Drive
w/6ft. gate
3ft. 38-1/2" 76" 88" 100" 111"
4ft. 50-1/2" 88" 100" 112" 123"
5ft. 62-1/2" 100" 112" 124" 135"
6ft. 73-1/2" 111" 123" 135" 146"