# 9"
K
ELECTRODE SETTING
BURNER START-UP CYCLE
ONLY FOR LIGHT OIL
ADJUSTMENTS, TO AVOID FLAME - DETACHMENT, AT BURNER IGNITION
M<-)$-(4.(C1(-1(41$4+($.4405/$;<1($*<1$*13815+*051$.@$*<1$,-7<*$.-,$21451+)1)$N1,.;$oF$Y=S
1) CORRECT POSITIONING OF THE ELECTRODES
%Z11$@-7S$#&
2) PUMP - SETTING
V<1($*<1$*13815+*051$.@$*<1$,-7<*$.-,$21451+)1)$N1,.;$oF$Y=/$-(451+)1$*<1$851))051$*.$9L$N+5S
3) COMBUSTION-HEAD SETTING
`170,+*1$*<1$4.3N0)*-.(T<1+2$.(1$)1*T8.-(*$@05*<15$+<1+2$*<+($-(2-4+*12$-($*<1$-()*504*-.()S
Example:$ the instructions require to set the combustion-head on set-point 3.
Instead, the setting is made on set-point 4.
4) FAN - AIR DAMPER ADJUSTMENT
a2k0)*$*<1$+-5$2+3815$.@$*<1$@+(/$)04<$+)$*.$.N*+-($+$)3.?1$(03N15$(.*$-(@15-.5$*.$9S
%-S1S$$+$4.3N0)*-.($;-*<$*<1$,.;1)*$8.))-N,1$1b41))T+-5&S
Attention:
:1@.51$513.C-(7$.5$+))13N,-(7$*<1
(.__,1/$,..)1 ($ *<1$)451;$ (A)$+( 2
3.C1$*<1$1,14*5.21)$+<1+2S
2 – 2.3 mm
4 [$0.3 mm
IMPORTANT:
THESE DIMENSIONS
MUST BE OBSERVED
BR #"
A
Fig. 3
Q.53+, I.4?T.0*/$201$*.$,-7<*T@+-,051
M<153.)*+*
E.*.5
'7(-*-.($*5+()@.5315
J+,C1
W,+31
I.4?T.0*$,+38
]$12s
BR !
]$12s
]$5s
To Next Page
Loading...
