To Next PageTo Next Page
Need help?Do you have a question about the Certikin MB50C and is the answer not in the manual?
Emphasizes severe consequences of non-compliance, including fire and explosion risks.
Immediate steps to take if a gas smell is detected to prevent ignition.
Details on controlling pool temperature and understanding status indicators like overheat.
Explains water pressure switch function and condensate blockage indication.
Guidance on cleaning, mandatory servicing, and preparing for winter.
Overview of heater type, flue systems, models, and chemical compatibility.
Legal requirements for gas appliance installation by competent persons.
Guidelines for choosing an appropriate installation location considering flue and drainage.
Specifies minimum distances for flue terminals from windows, vents, and corners.
Information on air supply requirements and suitability for outdoor installation.
Details on condensate trap connection and pool pipework installation.
Specifies wiring standards and connection methods for electrical supply.
Outlines space needed for installation/service and a step-by-step guide.
Describes outdoor terminal assembly and different flue system components.
Details on installing wall and roof terminals, including drill diameters.
Provides physical dimensions for Genie 35 and Genie 50 models.
Identifies connection points for pool water, gas, and electrical supply.
Specifies dimensions and requirements for horizontal wall flue terminals.
Illustrates outdoor flue terminal setup and dimensions.
Shows vertical roof terminal installation for pitched and flat roofs.
Demonstrates common flue setups like outdoor, wall, and roof terminals.
Lists kit codes for flue system components and their compatibility.
Details Flue Equivalent Length (FEL) for components and the 20m limit.
Instructions on assembling flue parts, including lubrication and inclines.
Specific instructions for fitting wall, outdoor, and roof terminals.
Details water flow, pressure, and series plumbing for the heater.
Step-by-step guide for converting the heater from Natural Gas to LPG.
Explains gas connection requirements and testing for leaks.
Instructions for altering condensate drain direction and connection methods.
Provides a rating table for gas rates and combustion values.
Illustrates methods for disposing of condensate, such as soakaways.
Guidance on cleaning the condensate syphon.
Details wiring standards, isolator types, and cable specifications.
Steps for commissioning the heater, including air purging and safety checks.
Instructions on how to enter and use the control's setup mode.
Details on changing display units from Fahrenheit to Centigrade.
Explains the benefits of connecting multiple heaters for load sharing and redundancy.
Step-by-step guide for installing the multiple heater interconnection kit.
Describes how the master and slave heaters function together.
Explains key features and how displays indicate status and faults.
Provides a detailed wiring diagram for the heater's electrical components.
Explains the normal operation and ignition sequence of the heater.
Details how safety controls and lockouts are indicated on the control panel.
Describes special modes for diagnostics and detailed temperature display.
Explains fault codes displayed on the front panel and their meanings.
Details fault conditions indicated by LEDs on the Printed Circuit Board (PCB).
Identifies faults related to open or short circuits in various sensors.
Explains faults related to the pool potentiometer and network detection.
Lists essential checks for maintaining efficient operation.
Guidance on inspecting pipework and cleaning the condensate syphon.
Procedures for replacing components like the fuse, thermostat, and gas valve.
Details on replacing the transformer, various thermostats, and pressure switches.
Procedures for replacing sensors, ignition control, and gas valve.
Instructions for replacing the fan and gas valve components.
Steps for removing and replacing the Venturi assembly.
Detailed procedure for removing and replacing the main heat exchanger.
Catalog of primary spare parts with item and part numbers.
Visual identification of key electrical components on the chassis.
Diagrams showing heat exchanger, sensors, and combustion components.
Visuals of fan, venturi, gas valve, and related parts.
General| Brand | Certikin |
|---|---|
| Model | MB50C |
| Category | Swimming Pool Heater |
| Language | English |
