CERUS Titan CI-050-P4

Need help?

Do you have a question about the CERUS Titan CI-050-P4 and is the answer not in the manual?

Summary

Installation, Programming Operation, & Maintenance Manual

CAUTION, SAFETY WARNING

General safety warnings and cautions for operating electrical products. Read manual thoroughly before operation.

Safety Instructions and Symbols

General Safety Instructions

Instructions to prevent injury and property damage during VFD installation and operation.

Warning Statements

WARNING

Critical warnings regarding electrical shock hazards during wiring and maintenance.

CAUTION

Chapter 3 - Installation and Wiring

Installation Precautions

Essential precautions for safely installing the VFD, including handling, environment, and mounting.

Basic Wiring Diagrams

Illustrations and guidelines for power and control wiring connections for VFDs.

Control Circuits Wiring

Power Wiring

Recommendations and diagrams for VFD power wiring, including grounding and wire sizing.

Chapter 4 - Operation

VFD Programming Keypad

Programming the VFD Parameters

Step-by-step guide on navigating and programming VFD parameters using the keypad.

Control Modes

Chapter 5 - Parameter List

[SET] Setup Parameter Group

List of parameters for application selection, motor data, and basic control settings.

[DRV] Drive Parameter Group

List of parameters for drive control, including command frequency and step frequencies.

[FG1] Function Group 1 Parameter Group

List of parameters for Function Group 1, covering acceleration, deceleration, and pre-heat.

[FG2] Function Group 2 Parameter Group

List of parameters for Function Group 2, including trip information and auto-start settings.

[I;O] Inputs;Outputs Parameter Group

List of parameters for configuring digital and analog inputs/outputs.

[APP] Application Parameter Group

List of parameters for application-specific functions like PID control and auxiliary motors.

[COM] Communication Parameter Group

Chapter 6 - Parameter Description

6.1 Setup Group [SET]

6.2 Drive Group [DRV]

6.3 Function Group 1 [FG1]

Description of FG1 parameters for acceleration, deceleration, pre-heat, and start modes.

6.4 Function Group 2 [FG2]

Description of FG2 parameters for fault history, jump frequencies, and auto-tuning.

6.5 Input;Output Group [I;O]

Description of I/O parameters for analog inputs, pulse inputs, and digital inputs.

6.6 Application Group [APP]

Description of APP parameters for PID control, auxiliary motors, and alternation modes.

6.8 Communication Group [COM]

Chapter 7 - PID Control Wiring and Block Diagram

VFD Wiring for PID Control

Wiring diagram showing connections for PID control using keypad and analog inputs.

PID Control Block Diagram

Block diagram illustrating the PID control loop and related operation parameters.

PID control Sleep mode with Sleep Pressure Boost function diagram

PID control with Pipe Broken function diagram

PID control with Pre-PID function diagram

Chapter 8 - Troubleshooting & Maintenance

Fault Display

List of VFD faults, protective functions, and descriptions displayed on the keypad.

Fault Remedy

Table providing common causes and remedies for VFD faults and protective functions.

Troubleshooting

Common troubleshooting scenarios for VFD operation issues like motor start, speed, and current.

Checking VFD Power Components

Maintenance

Chapter 10 - Modbus-RTU Communication

Introduction to Modbus-RTU Communication

Modbus-RTU Communication protocol

Parameter code list

List of VFD parameters accessible via Modbus-RTU communication with addresses and values.

Warranty Information

IN-WARRANTY service information

Procedure for obtaining service for defective parts under warranty.

OUT-OF WARRANTY service information