EasyManua.ls Logo

Cessna 172 Skyhawk - Landing Procedures

Cessna 172 Skyhawk
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BEFORE LANDING.
(1) Fuel Selector Valve -- "BOTH."
(2) Mixture -- Rich.
(3) Carburetor Heat -- Apply full heat before closing throttle.
(4) Wing Flaps -- As desired.
(5) Airspeed -- 70 to 80 MPH (flaps up), 65 to 75 MPH (flaps down).
BALKED LANDING (GO-AROUND).
(1) Power -- Full throttle.
(2) Carburetor Heat -- Cold.
(3) Wing Flaps -- Retract to 20°.
(4) Upon reaching an airspeed of approximately 65 MPH, retract flaps
slowly.
NORMAL LANDING.
(1) Touchdown -- Main wheels first.
(2) Landing Roll Lower nose wheel gently.
(3) Braking -- Minimum required.
SECURING AIRCRAFT.
(1) Parking Brake -- Set.
(2) Radios and Electrical Equipment -- "OFF."
(3) Mixture -- Idle cut-off (pulled full out).
(4) Ignition and Master Switch -- "OFF."
(5) Control Lock -- Installed.
AFTER LANDING.
(1) Wing Flaps -- Up.
(2) Carburetor Heat -- Cold.
1-6
1-7

Table of Contents

Related product manuals