Cessna T303 - C. Fuel (Chapter 28).; D. Ice and Rain Protection (Chapter 30).; E. Landing Gear (Chapter 32).

CESSNA MODEL
T303 MAINTENANCE
MANUAL
CESSNA
PROGRESSIVE
CARE
MODEL T303
OPERATION
NO. 2
MECH
INSP
REMARKS
C. Fuel (Chapter 28)
(1) Fuel Strainer - Clean.
(2)
Fuel Selector
Valve - Check
for operation
and detents.
(3) Fuel System - Inspect plumbing and component mounting for
condition and security.
(4) Fuel Bays - Inspect for leaks, cracks and dents.
(5) Auxiliary Fuel Pumps - Inspect for leaks, operation; vent and
overboard drain for obstruction.
(6) Fuel Bay Filler - Inspect for damage, leakage stains and
broken components. Check lock position of the filler cap.
(7) Drain Valves - Check operation.
(8) Check
Valves - Check
operation.
D. Ice and Rain Protection (Chapter 30).
(1) Surface Deice System - Check for leaks, condition and
operation
of controls; lines
and clamps for security.
(2) Deice Boots - Check for abrasions, cuts, nicks and security of
mounting.
(3) Deice
Filter
- Clean.
(4) Propeller Deice Slip Rings, Brushes and Boots - Check for
condition operation and security of attachment.
E. Landing Gear (Chapter 32).
* (1) Main Gear
System - Check actuating
time and free fall (flight
check).
* (2) Main
Gear Assembly
- Check security
of installation
and
attach points for wear and condition.
* (3) Main Gear Shock
Struts - Check for evidence of
leakage and
proper extension; check strut barrel for corrosion, pitting and
cleanliness.
* (4) Main
Gear Wheel
- Inspect for
nicks, cracks, finish,
abrasions
and corrosion.
* (5) Main
Gear Tires
- Check for wear,
cuts and proper
inflation.
* (6) Main Gear Retraction Upper Arm - Lubricate.
*50-Hour
Requirement,
Refer to Paragraph 5-22,
B.
Page
2 of
6