Cessna T303 - D. Lights (Chapter 33).; E. Navigation and Pitot;Static (Chapter 34).

CESSNA MODEL
T303 MAINTENANCE
MANUAL
CESSNA
PROGRESSIVE
CARE
MODEL T303
OPERATION NO. 4
MECH INSP REMARKS
(3) Rudder Pedals - Check rudder pedals and rudder for freedom
of movement.
(4) Rudder Cables - Inspect cable tension and turnbuckle safety-
ing.
(5) Elevator Cables - Inspect cable tension and turnbuckle safety-
ing.
(6) Control Column - Inspect control column for evidence of
damage, failed fasteners and security. Check control column
for freedom of movement.
(7)
Electric Elevator Trim - Operate
electric elevator trim.
Check
trim tab travel.
(8) Flap Motor
and Position Indicator -
Check travel, condition
and security.
D. Lights
(Chapter
33).
(1) Cockpit
Floodlights - Inspect for
damaged; lens and electrical
components.
Check
operation.
(2) Instrument
and Circuit Breaker
Panel Lights - Check opera-
tion.
(3) Annunciator
Panel - Inspect
for security
and evidence
of
damage.
Actuate
the test mode.
(4) Passenger Compartment
Lights - Check for
damage and
operation.
(5) Cabin Information
Display - Inspect indicator
for security of
installation, evidence of
damage, damaged electrical
compo-
nents and operation.
E.
Navigation and Pitot/Static
(Chapter
34).
(1) Airspeed
Indicator,
Barometer
Pressure
Altimeter and
Verti-
cal Speed
Indicator - Inspect for
security of installation,
cleanliness and evidence of damage.
(2) Magnetic
Compass - Inspect
for security of installation,
cleanliness and evidence of damage. Calibrate the compass.
(3) Turn
and Bank Indicator or Turn
Coordinator - Inspect for
security
of installation, cleanliness
and evidence of damage.
(4) Horizon
Gyro - Inspect for security
of installation, cleanliness
and
evidence
of damage.
(5) Adherence to all FAR's
that apply to flight instrument
repair
and accuracy is required.
(6) Direction Gyro - Inspect
for security of installation,
cleanli-
ness and evidence of damage.
(7) Stall Warning System - Check vane for freedom of movement,
security. Actuate and check horn.
*50-Hour
Requirement,
Refer to Paragraph 5-22,
B.
Page 2 of 7