DC112d/DC112
User’s manual
11
Once the batteries have been replaced,
simply switch on the device by pressing
and press to continue the
measurement.
The DC112d/DC112 can also be
powered via the USB port. To do this
connect the USB port of the
DC112d/DC112 [
8] to a USB port of a PC
with the cable provided. When it is
connected the
symbol will appear
where the battery symbol was.
RECOMMENDATIONS:
If the DC112d/DC112 is likely to be
unused for an extended period of time, remove the batteries from the DC112d/DC112 in
order to prevent damage caused by battery leakage.
We recommend that you always carry new replacement batteries
2.1.3 Connection and disconnection of the microphone
Before connecting or disconnecting the P007
microphone of the DC112d/DC112 dosimeter, make
sure the DC112d/DC112 is switched off.
To connect the microphone to the dosimeter, hold
the male plug of the microphone [
4] in the middle.
Insert it into the female socket [
5] of the dosimeter,
and press until it clicks.
To disconnect the microphone, hold the male plug of
the microphone in the middle [ 4]. Pull upwards on
the plug until disconnects.
IMPORTANT: Do not pull on the end of the plug by
the cable, as it will not disconnect. Similarly, do not
try to disconnect it by twisting the plug. In both cases
the device could be damaged.
To Next Page
Loading...