DC112d/DC112
User’s manual
25
viewed with the DC112d/DC112; the message “RECORDING INCOMPLETE” will appear on
screen when this is attempted. However it will be possible to download it to a computer using
Capture Studio. Following these measurements, more registers can be recorded as long as
the capacity allows.
3.2.1 Continuing a recording after the DC112d/DC112 has been
switched off
The DC112d/DC112 allows for a recording that has been interrupted (pause ) to be
continued after switching off the dosimeter. To do this, proceed as follows:
• Interrupt the recording in progress by pressing .
• The recording will stop and the recording status indicator will change from to .
• Switch off the DC112d/DC112 by pressing .
When you wish to restart the measurement
• Switch on the DC112d/DC112 by pressing .
• The measurement will appear on pause ( ).
• Press to continue the measurement. The DC112d/DC112 will continue saving the
values measured in the same register.
3.3 Viewing the register
This option allows you to display on screen the final result of the registers stored in the
DC112d/DC112 memory. Access the option by selecting MEMORY Î VIEW REGISTER
from the DC112d/DC112 menu.
By pressing
, and , the DC112d/DC112 allows you to select the
register you want to view. The screen will display an index of all the registers stored in the
memory (register number + date and time when the measurement process began).
To view the different functions, follow the procedure described in section
2.3.3.
3.4 Erasing the memory
This option enables you to wipe the memory completely. The DC112d/DC112 asks for
confirmation before erasing. MEMORY Î ERASE MEMORY.
To Next Page
Loading...