CESVA DC112 - Page 18

16
To set these parameters select the SETTINGS Î MEASURING Æ DOSIMETER option
from the DC112d/DC112 menu.
When the previous screen appears, select the parameter you want to configure L
C
, t
p
or T
using the
and keys, then press . Use the key to cancel.
To modify the L
c
parameter, proceed as follows:
• Select the numerical value using and keys and press .
To modify the t
p
parameter, proceed as follows:
• Set the hours value using and and press to confirm, repeat this
process to set the minutes value. The projection time t
p
is set from (HH:mm:00):
o 0 to 99 for HH (Hours)
o 0 to 59 for mm (minutes)
The minimum projection time is 1 minute.
To modify the T parameter, proceed as follows:
• Select the numerical value using and and confirm by pressing . T
integration time may be set from
o 1 to 59 seconds (1’’ – 59 ’’)
o 1 to 59 minutes (1’ – 59’)
o 1 to 99 hours (1H – 99 H)
• Finally select the time units: seconds (“), minutes (‘) or hours (H) with the help of
and
and press to confirm. Use to cancel or return to the menu.
To set the frequency weighting applied to the spectrum access the menu of the DC112 and
select SETTINGS Æ MEASURING Æ SPECTRUM ANALYSER
When the above screen appears, select YES or NO using the
and keys,
depending on whether you wish to apply A frequency weighting or not, and press
.